Wireless fire detector with temperature and carbon oxide sensors that monitors security in the room twenty four hours a day and immediately notifies of dangerous CO levels, smoke and sharp jumps in temperature.
• The device registers smoke, sharp jumps in temperature, and dangerous CO levels
• It can operate independently from Ajax Hub, notifying of danger by means of a built-in siren
• The device independently tests the smoke chamber and gives prompt notification of the need to dust
Principle of operation
The device detects smoke by means of a camera with a photoelectric sensor. An additional chemical element detects carbon oxide and raises the alarm.
It can operate independently from the hub, emitting a fire alarm by means of a built-in siren. Several detectors indicate an alarm simultaneously.
Installation and set up
Ready to operate straight out the box: the battery is already installed, therefore there is no need to disassemble the detector. With one click, it can be connected to the hub in the mobile application. It can be mounted on the SmartBracket in just a few minutes.
Radio channel smoke detector with temperature sensor and built-in siren
Type of detector
Photoelectric, CO and temperature sensors
+54°С to +65°С
Type of notification
Volume of built-in siren
Alarm signal delivery time
False alarm filter
Battery: Two CR2 batteries
Power supply voltage: 3 V
Battery life — up to 4 years
Backup power supply: battery CR2032
Additional temperature sensor
Up to 80%
Protection against fraud
Remote setting and testing
Replacement and repair within 24 months of the date of sale. Batteries are not covered under warranty.
FireProtect Plus detector
SmartBracket mounting panel
2 x CR2 batteries (pre-installed)
1 x backup battery CR2032 (pre-installed)